SmartFan® Stratus II

Variable Frequency Drive AC Motor Speed Control

Stratus Variable Frequency Drive AC Motor Speed Control

SmartFan Stratus II Variable Frequency Drive


 

 

Fig. 1: Stratus II Variable Frequency Drive AC Motor Speed Control with Cover Model VFD400E-F

 

Fig. 2: Stratus II Variable Frequency Drive AC Motor Speed Control Model VFD400-F

 


SmartFan Stratus II Variable Frequency Drive AC Motor Speed Control

SmartFan Stratus II is a microprocessor based variable frequency drive designed for OEM applications in HVAC, electronic and industrial control markets. Stratus II is designed to control single or three-phase fans, motors and pumps in AC motor speed control applications including environmental control (temperature, humidity, pressure, flow), clean room pressurization, equipment cooling, exhaust ventilation and heating/air conditioning systems.

Stratus II allows easy set-up for Variable Frequency Drive motor control based on an analog control input or fixed speed settings. For added versatility, Stratus II can be programmed and controlled using Modbus communications.
The ease of operation, small size and innovative microprocessor design make the Stratus II the most cost effective variable frequency drive available for low power AC motor speed control.

Benefits of using SmartFan Stratus II Variable Frequency Drive AC Motor Speed Control include acoustical noise reduction, environmental (humidity, temperature or pressure) regulation, greater product reliability, increased fan life, improved safety and energy savings
.

CAUTION: SmartFan AC motor speed controls are designed for OEM (Original Equipment Manufacturers) and are not intended for end-user or after-market applications. SmartFan AC motor speed controls should only be used with compatible induction motors: Permanent Split Capacitor (PSC) or Shaded Pole. All AC motors must be approved by the motor manufacturer or thoroughly validated prior to use. Attempting to control a fan or motor that is not compatible could cause excessive heating and/or permanent damage to the motor.

The use of Inverter duty grade motors is highly recommended when using a Variable Frequency Drive. To avoid bearing pitting and insulation breakdown on motors that are not inverter grade, the use of a LC filter connected to the output of the Variable Frequency Drive is required.
Control Comparison & Motor Efficiency
See technical article on how the Stratus II Variable Frequency Drive AC motor speed control compares to other controller technologies.

Features - SmartFan Stratus II Variable Frequency Drive AC Motor Speed Control

  • Single phase input / single or three-phase output
  • Programmable control parameters including:
    • Motor speed and direction
    • Output frequency
    • Motor phase
    • Acceleration and deceleration rates
    • Motor startup speed and on/off at idle
    • Current trip limit
    • Fully configurable control slope
  • Over current and over temperature protection
  • On-board Status / Fault LEDs and remote alarm signal indicate loss of control signal, over temperature or over current conditions
  • Contact closures allow On / Off and 3 speed setting options
  • Optional steel cover
  • Fan compatibility: For maximum motor life, the use of an inverter grade motor is recommended.

Specifications - SmartFan Stratus II Variable Frequency Drive AC Motor Speed Control

  • Input Power: 115 & 230 VAC ±10%, 47-64 Hz
                         Single Phase, 5.7 Amps
  • Output Power: 115 & 230 VAC ±10%, 0-400 Hz
                          Single or Three-Phase, 4.0 Amps
  • Programmable carrier frequency 2 - 20 kHz (default: 16 kHz)
  • Controls fan / motor speed based on:
    • 4-20 mA, 0-5 or 0-10 VDC analog control signal
    • Modbus interface
    • Potentiometer
    • Temperature sensor (thermistor)
  • Non-isolated control options
    • Contact closure
    • Fixed speed switch
    • Potentiometer
    • Temperature sensor (thermistor)
  • Storage Temperature: -40°C to 125 °C
  • Operating temperature: -20°C to 40°C (full load)
  • Weight with cover: 1.8 lbs (820 grams)
  • Weight withour cover: 1.2 lbs (545 grams)
  • RoHS (6/6) compliant
  • UL recognized to UL508C, File E331664


OEM AC Fan Speed Control - SmartFan Stratus II


OEM AC Fan Speed Control - SmartFan Stratus II

Part Numbers - SmartFan Stratus II Variable Frequency Drive AC Motor Speed Control

Stratus II Control Mode Enclosure

VFD400E-F

VFD400-F

VFD401E-F

VFD401-F

Stock Product All Isolated and Non-isolated control options

All Isolated and Non-isolated control options (50 piece minimum order)

Non-isolated control options only (50 piece minimum order)

Non-isolated control options only (50 piece minimum order)

Yes

No

Yes

No


For Modbus communications support, try the following links:


Manual Pages - SmartFan Stratus II Variable Frequency Drive Motor Speed Control

Use the links below for addtional manual pages or for a complete manual or click on the Operation/Installation Manual PDF link above.





Control Resources Home | News and Info | Technical Data | Catalog | Contact Us | Applications | About Control Resources | Site Map
Control Resources Incorporated 11 Beaver Brook Road Littleton MA, 01460 USA Tel: 978-486-4160 Fax: 978-486-4772 email: sales@controlres.com